• Sue-Ellen became a registered member 27 minutes ago

  • Jessica became a registered member 4 hours, 46 minutes ago

  • Steph Lin became a registered member 7 hours, 49 minutes ago

  • Lance Foust became a registered member 8 hours, 38 minutes ago

  • @urajan Regardless of what AIAG says you need to spread the samples out. You need to be across the spec limit and outside the spec limit.

    If you have a random number generator make some sets of numbers and run them so you can see the effect. Try running a bunch that are the same size and in the middle of the spec. See how that one turns out.

    I…[Read more]

  • @trolin If this is an academic exercise to teach how to do this I wouldn’t worry to much about it. Stay conventional and focus on inventory or time. Depending on the instructor if you stray to far from that don’t be surprised if they don’t understand what you are doing.

    Just my opinion.

  • DavidIngram‘s profile was updated 13 hours, 43 minutes ago

  • DavidIngram became a registered member 13 hours, 45 minutes ago

  • From AIAG MSA Manual 3rd ed pg.74 stated as ” the sample parts must be selected from the process and represent the entire production operating range”

    Until today many of us has this dilemma on sample selection. The definition is not well defined by AIAG. Many of the people in this forum fail to address the definition precisely and quite vague.…[Read more]

  • Mr.t, what a well written DMAIC problem solving methodology. This simple yet very informative help my understanding well on theis topic. Hat’s off to you man.

  • From AIAG MSA Manual 4th ed pg.74 stated as ” the sample parts must be selected from the process and represent the entire production operating range

    Until today many of us has this dilemma on sample selection. The definition is not well defined by AIAG. Many of the people fail to address the definition precisely and quite vague. Hope someone can…[Read more]

  • Thomas Chatzis became a registered member 17 hours, 1 minute ago

  • @trolin7 How did you arrive at this process as your project? If there was something specific you wanted to measure and analyze then that is what you start with. If there is a corporate initiative to do something it would be a great career move to start there.

    If you picked this for no particular reason the do it all. If you have no clue what you…[Read more]

  • Richard F Black became a registered member 1 day, 9 hours ago

  • Stephanie became a registered member 1 day, 11 hours ago

  • Daniela Britto became a registered member 1 day, 12 hours ago

  • hakmas janz became a registered member 1 day, 17 hours ago

  • defects, cycle time, lead time, inventory, throughput are typical focuses.

    you never know what you’ll find if you’re new to the process.

  • Damon Werner‘s profile was updated 2 days, 3 hours ago

  • Jim Riley became a registered member 2 days, 9 hours ago

  • Load More